https://www.maynenkhitrucvit.com.vn/en/news/gerneral-technology/ vi Sun, 23 Dec 2018 14:12:00 GMT Sun, 23 Dec 2018 14:12:00 GMT https://www.maynenkhitrucvit.com.vn/en/rss/ https://www.maynenkhitrucvit.com.vn/uploads/logo_4fb9ca99fae2942f256b229062eefe34.jpg https://www.maynenkhitrucvit.com.vn/en/news/gerneral-technology/ 45 https://www.maynenkhitrucvit.com.vn/en/news/technology/why-must-prevent-machines-from-lubricant-amulsion-69.html Sun, 23 Dec 2018 14:12:00 GMT In the process of using air compressor oil, due to poor preservation process or any causes that makes lubricating oil mixed with water. If the water is not separated, the emulsion will be formed and the water is kept in the form of emulsion. So, what do these emulsions affect? Are there any cases that need to create emulsions? ... The following article will help you better understand this problem.]]> https://www.maynenkhitrucvit.com.vn/en/news/technology/how-to-control-lubricants-51.html Thu, 20 Dec 2018 02:12:34 GMT If the compressor oil runs out of viscosity without replacement, it will stick on oil separator and heat separator due to oxidation. Always replace lubricants and oil separator according to maintenance standards. Dirty oil may cause the oil separator burnt. Check the lubricanting level with the oil level gauge on the oil case when the machine is operating (loading operation). Normally if it is between 2 red lines. when it's over the upper red line showing excessive oil. Stop the air compressor and then check if there is any residual pressure remaining inside, discharge excess pressure with the draining valve on the oil case etc.]]> https://www.maynenkhitrucvit.com.vn/en/news/technology/releplishment-of-oil-air-compressor-48.html Wed, 19 Dec 2018 08:12:03 GMT Peridiodical replenishment is necesssary improving the durability , indicident decrease, stable operation in factory. However, the correct replenishment is vital. Failure to observe it may cause the hot oil to gush and you maybe burnt ....This articles is useful for you.]]> https://www.maynenkhitrucvit.com.vn/en/news/technology/flash-point-determination-method-47.html Wed, 19 Dec 2018 08:12:53 GMT Flash point, the lowest temperature at which a liquid (usually a petroleum product) will form a vapour in the air near its surface that will “flash,” or briefly ignite, on exposure to an open flame.]]>