Part list of Handsome II air compressor

Wednesday - 31/07/2019 22:20

When ordering parts, specify the machine type , part name, part numbers to our authorized distributor. Use Kobelco genuine parts when replacing worn parts or repairing. Using non-genuine parts does not guarantee  proper funtions and may result in a failure.

Parts  Parts number HM37A HM37AD
Dust filter Left side face P-CE05-521 2 2
Right sude face P-CE05-554 2 5
Suction filter element S-CE05-503 1 1
Oil filter cartridge P-CE13-520 1 1
Volumetric regulating valve diaphragm. 4J11V01001P1 1 1
Presure keeping check valve. P-FC12-527 1 1
Solenoide valve. 0,69 MPa P-FC81-624 1 1
0,83 MPa P-FC81-598#01 1 1
Oil separator element.
 
P-CE03-572 1 1
Temperature control valve. P-FC61-502#03 2 2
Safety valve. 0,69 MPa P-FC21-535#01 1 1
0,83 MPa P-FC21-535#02 1 1
Pressure control valve. P-V31-003 1 1
Discharge temperature sensor. P-EA01-571#03 1 1
Oil recovery check valve. 4F04V01008F1 1 1
Silencer. P-CD01-510 1 1
Mechanical seal. P-GA05-521 1 1
Pressure switch 0,69 MPa P-EA02-566#05 1 1
0,83 MPa P-EA02-566#04 1 1
Poly V-belt 50 Hz P-AE24-596#09 1 1
60 Hz P-AE24-596#07 1 1
Drain separator P-FC41-501 1 -
           
                                 *Smaller parts such as packing and O-rings that are to be changed along with major parts are omitted.
8.3 Adjustment of  Poly V-belt and Pulleys.
  • Adjusting tension of poly V-belt
Measure the tension of the poly V-belt using a frequency measuring instrument. Be sure to adjust the tension  to the specified value. Excessive tension may cause belt rotor shaft or reduction in bearing life, whereas insufficient tension may cause belt slipping. Adjust frequency with adjusting bolts using a frequency measuring instrument.
Frequency adjustment using frequency measuring instrument.

                                 

 

Frequency of power supply.

50 Hz

60 Hz

STD (0,69 Mpa {7,0 kgf/cm2}

102Hz

98Hz

H (0,69 Mpa {8,5 kgf/cm2}

100Hz

96Hz

 
  • Aligning pulleys

Fit a ruler at the ends of large and small pulleys, and make sure that the clearance between them is 1.0 mm or less.
 

Total notes of this article: 0 in 0 rating

Click on stars to rate this article